Carebot Robot
Get hands-on with robotics by building your own bot from the ground up. In this workshop, you’ll assemble 3D-printed parts, and wire up servos to a micro:bit and robot:bit to bring your CareBot to life
Make sure electronics are not connected to a power supply when assembling.
Test your components often during assembly.
This document assumes that you have gone over
Introducing Otto Hardware and
Introducing Otto Software
Material List
Safety First
Make sure electronics are not connected to a power supply when assembling.
Power should never be connected to components while assembling.
Keep water away from workstation at all times.
Don’t use force to connect parts. Need help? Ask!
Otto Build Guide
Before You Start!
Test your servos.
- Use a simple code to make sure your servo is functioning and can move to 2 different positions.
- Set each servo to 90 degrees before installing it.

You have 3 resources to use. Compare them to each other and the exemplar bot. When something is confusing, you can circle it.

